New profile posts

Hi Bobby
I have the bosch saw you are considering purchasing, plus the wheeled stand; both items are like new. If you are interested, then personal message me, I'm in Lancashire.

believe, and all will be good.

I have a McCulloch M40-110 Classic lawnmower and need to service the carburetter and need to replace the pull cord. However, I cannot remove the engine cover to get at the Carb or cord pulley. I have removed the two bolts on top of the engine cover at the front, but there seems to be fixings at the rear of the cover.
Does anyone know how to remove the cover?
Many thanks

Help needed fagor boiler issue

Adam could you please explain how you know it’s a floating system…..

What is it in the diagram that’s telling you that…I’m having to fill out a form to get certification to use the system…it’s a real pain but I remember you saying this and it could be very relevant…..Mike

Hi Woody, Sorry for the trouble. It would be a great help if you could give any advice to this please : https://www.diynot.com/diy/threads/horizontal-crack.643643/#post-5952162

Thanks in advance.

Problem with my honeywell back boiler the radiators only get hot if l put the water on first snd then go cold went the hot water tank is hottank

DIYer

I have on my condensing boiler water outlet pipe inside just below the boiler a diverter that I can divert water into a plastic bucket I cut a piece out of the pipe and replaced over the pipe with a see through pipe that has a red ball in and a knob to turn so when outside pipe freezes up I have the knob turned so water goes down a plastic tube into the bucket. Had it for 4 years and no struggling to defrost outside

Following earlier post on location of fuse on potterton suprima 30. I've now located it and it's fine,but still can't find out why I have no lights on board.Power is going into the board.I 've checked for voltage around the board and some components are only showing about 120 volts?.I've tried disconnecting components ie pump,gas valve, thermostat etc.Makes no difference

Hi Eric Mark.
You seem to have amazing knowledge about smart heating. I'd love some advice about splitting my house into 2 zones. I have an extension that I want to split off by plumbing, not using TRVs, so that it can trigger the boiler independently if needed but there's no water flowing into that area when it's off. Can you advise? Thanks!

Ok so I just got a Worcester Bosch 4000 boiler, It modulates, however their stat is junk and cant cope with metal walls, looses connection and is so slow I discarded, looked at tado, t6r honeywell, hive and nest none talk to boiler as wrong language of OT, the t6 r is tpi and boiler and rads set up for low temp run @ 50 deg c so should always condense, what are others thoughts on this if any?

Just Chilling

Smeg DD612 dishwasher.
Machine fills with water and empties to floor as well even turned off at Fused Switch and the water supply after use.
Is this the air break seals that can cause such a volume of water or is the actual Aquastop attached at the water inlet causing it.