Purchased a new 9.5kW electric shower and would like to know if can install using the existing wiring and MCB.
The existing wiring is 6mm approx 12m run with 50A MCB and goes through a 45A DP pullcord switch.
Would this be sufficient?
Or would i require to upgrade the cable to 10mm or change MCB to 45A.
Any suggestions would be most appreciated.
Thanks
The existing wiring is 6mm approx 12m run with 50A MCB and goes through a 45A DP pullcord switch.
Would this be sufficient?
Or would i require to upgrade the cable to 10mm or change MCB to 45A.
Any suggestions would be most appreciated.
Thanks