An initial cut with a straight cutter is required to produce the drawer pull profile. D 19 mm C 13 mm R 4 mm Overall Length 48 mm Shank Diameter 1/4 inch

Standard duty arbor with 1/4 inch spindle and spacers. OL 76 mm Spigot dia. 1/4 inch Spigot dia. 6.35 mm Spigot length incl thread 34 mm Spigot thread length 11 mm

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. All cutters above and including 9.5mm diameter, have TCT plunge centre tips. D 15/32 inch D 12 mm C 19 mm OL 51...

Bearing guided intumescent strip cutter for routing the groove for intumescent strip in a frame or door. D 40 mm C 10 mm B 32 mm E 4 mm L 41 mm

Profiler with shank mounted bearing guides. D 3/4 inch D 19.1 mm C 50 mm B 19.1 mm A 90 degrees

Useful for bevelling thick timbers. D 26 mm D2 12.7 mm C 35 mm C2 36 mm B 12.7 mm A 80 degrees

For biscuit jointing of timber, man-made fibre and particle board with the router. D 40 mm C 4 mm B 15 mm B2 19 mm B3 23 mm Shank Diameter 1/2 inch

Machining of traditional panels and frame doors, formerly done on spindle moulders, can now be performed with heavy duty routers mounted in fixed positions, either overhead or inverted. These Raised Panel cutters run best at lower speeds and match our...

Recessing cutter will accommodate the Schlegel Aquamac 21 or Exitex Aquatex A10 seal. D 46.3 mm D2 34.3 mm C 10.3 mm C2 2.7 mm OL 90 mm B 28.6 mm

Machining of traditional panels and frame doors, formerly done on spindle moulders, can now be performed with heavy duty routers mounted in fixed positions, either overhead or inverted. These Raised Panel cutters run best at lower speeds and match our...