Any advice greatly apprecited.
I added two new radiators to my central heating system but cant get them to work.
Firstlty the set up is like this:
//media.diynot.com/14000_13165_30381_66365221_thumb.jpg
[GALLERY=media, 30381][/GALLERY]
I bled the air and the new runs of pipework are all full of water. The pipes get progressively cooler as the they run along the roof void and are cold by the time they drop into the rooms with the new rads. I've fully opened all the valves on the rads but cant seem to get the water to flow.
All of my joints are made in simple "t" or ninety degree fittings. (I've replaced the drain plug but its not shown on the diagram)
I added two new radiators to my central heating system but cant get them to work.
Firstlty the set up is like this:
//media.diynot.com/14000_13165_30381_66365221_thumb.jpg
[GALLERY=media, 30381][/GALLERY]
I bled the air and the new runs of pipework are all full of water. The pipes get progressively cooler as the they run along the roof void and are cold by the time they drop into the rooms with the new rads. I've fully opened all the valves on the rads but cant seem to get the water to flow.
All of my joints are made in simple "t" or ninety degree fittings. (I've replaced the drain plug but its not shown on the diagram)