Search results

Have this problem in the upstairs toilet and not the down. During strong winds as the air blows over the top of the stack it will create a vortex with the relativly warmer air from your poo pipe. I have taken the time to connect a manometer to the stack itself and can see as the wind blowns a...

spot on. Or anouther alternativeis to fittwo boilers having both linked togeather for probably less than fitting a unvented cylinder.

Boring old timers. I completed my course through the dole. Although I have been working on gas and plumbing since I was 16 I did not get my gas ticket until I was 30, five years ago. Sonce then I have worked damm hard to get to the leaval im at now. I didnt rip people of on my journey and my...

sorry that did come accross abruptly as i wasnt following the thread. If the radiator wont come on with the trv in the fully open position the rubber has stuck and a gentle tap with a wooden batton will clear this, taking care not to wak the copper tube. If the radiators not turning off rubber...

Turnung the pump up is a good compensation for a problem with the thermostats inside the boiler but will only work for a short period of time. What boiler are you working on.

Giving things a thump with a hammer is not the answer. Has anyone thoughtthat the rubber washer has perished andisnot sealingtheinside of the valve. If i had seen that problem for 12.50 for a complete new and 30 mins work I would of just got on and changed the valve. Job done

If you turn the gas of the boiler will just do nothing. Just run the water through for a boit

You should have a drain off above the boiler. Connect a hose pipe securley with a jubiles clip and open. if a gravity system leave to run for a bit if pesurised just open the taps> Dont forget to open any divertor valeves. three ports etc>

So the answer after checking there is no flow ristriction through the DHW system(ie plate heat exchanger) and you have the correct mains inlet pesure is to see what the boiler parameters are set at. If its a new boiler you will have a benchmark form filled in, check it matches with what is in...

sounds like your hot water tank couldbe faulty. Turn on a hot tap and look at the quality of the water.

If theboiler hasbeen serviced and thenthe problem gas began chances are its a lose connection to cant remeberof handif it is a flame detection probe. More likely a termocouple been damaged or if the burner assembly was serviced, connections there.