Search results

Hi all i bought a rhyas table saw to help fit a wooden floor, all of a sudden it has stopped working i tried changing the bush but no joy is there an answer or is the answer in the thread title? Lep

the only valve i can see is a red one that seems to be on a cold pipe would that be the one. If it is do i close it and run the hot tap till the water stops. cheers T

Hi i need to change a tap washer on my sink(HOT), but can't find anywhere to turn off the hot water between the tank and the tap. Any suggestions. cheers T

I want to build a Hexagonal deck, i thought i remembered seeing a set of sort of galvanised bracket for doing this, or was i dreaming Josher

so should i get another flush and hope that it fits ?

i have got a flexi waste that fits but goes slightly uphill and was worried about using it

plumb world

i have just bought a flush pipe which is 1 1/2 inch but is to slack in the flushes. it seems like the actual pipe plastic is to thin. any help

I'm not sure if this is the right place but here goes. my garage door side "retaining" wire has snapped i managed to find a replacement which looks like it will fit, but i can't work out how to attache the top end on. ANY IDEA

having just mastered fitting cabinet doors mfi have given me a aventos hk slow close fitting i just can't work out where to fit it . Can any one help please??

i don't want to give the impression that i'm totally usless, but there you go. it came straight out of the car and is a blankpaunt?? a valencia cd52 is that any help also there are no wires just a socket

What would i ask for and where from, and if poss a rough price.

is it possible to get a plug in connector to get a car cd player to work from the mains?

the light switch clicks on and off but the bulb stays on

the light that went bang has an ordinary switch, i put a normal bulb back into it , but the switch will not turn off the bulb ,it goes to on and off but nothing happens

there was a bang when i put in a long life bulb in, then i tried a normal 100 watt bulb in and it went on even though the switch was off. Now when there is a bulb in the holder it stays on the switch has no effect at all. There has been nothing done to the light at all although i had to...

just a straight forward on off switch (does that mean a single pole)

i replaced a lightbulb and there was a bang. now the light will not go off at all. Can anybody help

i want to put an isolation valve on my cold and hot water supply, in the kitchen. Which should i use, push fit or compression?

If they did, i would be having a full english, instead of cereal for breakfast tomorrrow