Type S2R1B
FD 8406000306
?BKT? (unclear) 5108GB /01
further to my earlier thread, where I changed the seal that goes round the sides and top of the doorframe, and cleaned, lubricated and refitted the flaps that fasten to the outside edges of the door, I have been running it today with the door cover off to see where the drips are (still) coming from.
When run empty, with clean fresh water, it does not drip, but water spills into the stainless trough at the front, this seems to be an extension of the internal floor of the cabinet, and empties when the machine pumps out.
With mugs and pans inside, the machine foams up, even on prewash before it eats the detergent tablet, and continues foamy even when it pumps out the prewash and takes the tablet.
This foam builds up in the front trough and dribbles over the edge. I can see it coming in waves when the wash arms pass the front. It is as if there is no seal between the bottom of the door and the bottom of the cabinet. I can't see any trace of a rubber seal here, is there supposed to be one?
FD 8406000306
?BKT? (unclear) 5108GB /01
further to my earlier thread, where I changed the seal that goes round the sides and top of the doorframe, and cleaned, lubricated and refitted the flaps that fasten to the outside edges of the door, I have been running it today with the door cover off to see where the drips are (still) coming from.
When run empty, with clean fresh water, it does not drip, but water spills into the stainless trough at the front, this seems to be an extension of the internal floor of the cabinet, and empties when the machine pumps out.
With mugs and pans inside, the machine foams up, even on prewash before it eats the detergent tablet, and continues foamy even when it pumps out the prewash and takes the tablet.
This foam builds up in the front trough and dribbles over the edge. I can see it coming in waves when the wash arms pass the front. It is as if there is no seal between the bottom of the door and the bottom of the cabinet. I can't see any trace of a rubber seal here, is there supposed to be one?