Hi,
As covered in previous topics, the dial keeps clicking with 8 LED flashes on my Indescit WD12s.
This happens on all the programmes after the powder tray has filled, then it sounds as if the water pump is running to drain, although at this stage I would have thought there is little to drain away.....
I have checked all the electrical connections short of cutting back the heater element cables and re-terminating, and have reseated the pcb plugs too.
I'm thinking pcb at this stage due to the drain sequence out of sync, and previous posts.
Can anyone shed and light on this and advise what would a typical price would be for a new pcb.
many thanks
Paul Blit
As covered in previous topics, the dial keeps clicking with 8 LED flashes on my Indescit WD12s.
This happens on all the programmes after the powder tray has filled, then it sounds as if the water pump is running to drain, although at this stage I would have thought there is little to drain away.....
I have checked all the electrical connections short of cutting back the heater element cables and re-terminating, and have reseated the pcb plugs too.
I'm thinking pcb at this stage due to the drain sequence out of sync, and previous posts.
Can anyone shed and light on this and advise what would a typical price would be for a new pcb.
many thanks
Paul Blit