Hello All
My kitchen run has a dishwasher next to an under-worktop oven. Inbetween I'd planned to put an end panel to support the worktop.
I'd read on here (e.g. the below thread) that this end panel should be be brought out flush with the cabinet doors. Makes sense I think. But how to get the panel over the plinth/kickstand ?
Cut the end panel to slot over it or cut the plinth in two with one cut either side of the panel?
https://www.diynot.com/diy/threads/...e-and-tumble-drier-next-to-each-other.453723/
My kitchen run has a dishwasher next to an under-worktop oven. Inbetween I'd planned to put an end panel to support the worktop.
I'd read on here (e.g. the below thread) that this end panel should be be brought out flush with the cabinet doors. Makes sense I think. But how to get the panel over the plinth/kickstand ?
Cut the end panel to slot over it or cut the plinth in two with one cut either side of the panel?
https://www.diynot.com/diy/threads/...e-and-tumble-drier-next-to-each-other.453723/