HI All i need a little help i have flushed the system all water came out clean filled the system adding x100. The valve moves ok but hot water on its own and it struggles to get around the coil can i take the valve off by plugging the vent&feed ? i think it may be partly blocked.
mid position valve
- Thread starter harrison_633
- Start date
Sponsored Links
I have changed many 3port valves using the bung method as you describe. For an amateur it would be best to drain down enough to do the work you intend to do.
thanks for that i have used this method before on rads just making sure its ok on three port valve
Sponsored Links
As above, I'd drain it if I were you. Save yourself a ceiling!
It can be done but not best to try unless you've done them before. It doesn't act like a rad valve.
It can be done but not best to try unless you've done them before. It doesn't act like a rad valve.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
