Following on from my picture of the week thread, I am now in the position to repair the offending circuit which was damaged by rodents.
Now to avoid this happening again, I have agreed with the client to install something a little more substantial.
I have my own idea for the soloution, but just thought I'd see if I was missing anything obvious.
All the sockets are flush mounted, but the walls are ply boarded studwork. There is a crawl space under the floor to facilitate running the cables from the CU to the various sockets. I would like to reuse as many existing routes as possible just to make the job a bit easier.
Any comments, observations, ideas and inventions more than welcome
Now to avoid this happening again, I have agreed with the client to install something a little more substantial.
I have my own idea for the soloution, but just thought I'd see if I was missing anything obvious.
All the sockets are flush mounted, but the walls are ply boarded studwork. There is a crawl space under the floor to facilitate running the cables from the CU to the various sockets. I would like to reuse as many existing routes as possible just to make the job a bit easier.
Any comments, observations, ideas and inventions more than welcome