Hi guys,
Just joined this forum, I need some advice.
I currently have a Washing Machine installed, its connected to the cold feed and the waste as shown in the photos.
My dishwasher is coming next week, a dishwasher has never been installed in this property. It's going in the place of an under counter fridge so mains/electric is there.
I'm wanting to give it a go!
All the pictures show how it is all connected currently, picture 3 is the pipe just under the belfast sink with a shelf between the cupboard.
Picture 2 shows the cold feed which is currently connected to the washing machine.
Picture 1
Picture 2
Picture 3
My dishwasher won't be on this wall, therefore pipe work will have to be extended to reach.
However from my own research I think I need:
Mcalpine WM11 or Mcalpine SK1A (I'm unsure which one, I only have a 1 drain hole belfast sink, but unsure on which).
And
I only have the cold feed as shown in picture 2, from my research do I need a Y PIECE, but certain reviews have said a plastic one is no good, but a brass one would do the trick!
Then,
I think I just need a:
cold feed extension of 2-2.5m
and
waste pipe extension of 2-2.5m
Am I on the right wavelength here?
If anybody could help would be much appreciated, as I'm wanting to achieve to do this myself!
Cheers
Just joined this forum, I need some advice.
I currently have a Washing Machine installed, its connected to the cold feed and the waste as shown in the photos.
My dishwasher is coming next week, a dishwasher has never been installed in this property. It's going in the place of an under counter fridge so mains/electric is there.
I'm wanting to give it a go!
All the pictures show how it is all connected currently, picture 3 is the pipe just under the belfast sink with a shelf between the cupboard.
Picture 2 shows the cold feed which is currently connected to the washing machine.
Picture 1
Picture 2
Picture 3
My dishwasher won't be on this wall, therefore pipe work will have to be extended to reach.
However from my own research I think I need:
Mcalpine WM11 or Mcalpine SK1A (I'm unsure which one, I only have a 1 drain hole belfast sink, but unsure on which).
And
I only have the cold feed as shown in picture 2, from my research do I need a Y PIECE, but certain reviews have said a plastic one is no good, but a brass one would do the trick!
Then,
I think I just need a:
cold feed extension of 2-2.5m
and
waste pipe extension of 2-2.5m
Am I on the right wavelength here?
If anybody could help would be much appreciated, as I'm wanting to achieve to do this myself!
Cheers