Recent content by 144cas

Thanks John. Is this to diagnose a problem or might it fix things? I’ll try this later since all it will require is a bucket!

Thanks. Flow from boiler is going in at the bottom, return is coming out the left hand side. Can’t see a brand on the mixer, so not sure what is meant to be connected where unfortunately. But the pump has an arrow pointing up at least?

Hi crossthread, thanks for your speedy reply. It has been better in the past yes. Never 100% since I bought the house but it used to get upto around 60deg from memory. Is there any mileage in trying a power flush first - could that dislodge some gunk in the mixer etc? Or should I just replace...

Hello everyone, wonder if anyone here can advise. Long story short, my underfloor heating is not getting warm enough. It’s a wet system in my kitchen only. The rest of the house has radiators. The flow pipe from the boiler splits off to feed the UFH and the radiators/hot water cylinder. The...

Understood. Would you insist they scrap the wall and retile after tanking ? Irrespective of how thick the adhesive was set? Or does their theory of “it’s thick enough to prevent water ingress” hold true at some point Thanks again for your response .much appreciated.

Thanks Swwils. I suspected this was not to standard. But in reality, if the adhesive was thick enough on this other wall, is there any prospect of water ingress or is it possible that with sufficient thickness of adhesive, it can be considered “waterproof”

Hello. I’m having a Wetroom shower tiled. One side is a new wall made of Wedi boards which have been tanked. The other wall is an existing wall (mix of plasterboard and old lathe and plaster wall). Tilers have applied tile adhesive directly to that wall without tanking. On querying this with...