Recent content by Adrian80

So if your discharge from the appliance was less than 9m (including bends) to the common discharge it would need to be piped in 22mm. Then your "Common discharge" was say 9m to the ground, this would mean you would only need to size the "Common discharge" at 28mm to satisfy regs. Cheers A

Hi all, I have a slightly odd question about D2 discharge pipes from an unvented cylinder. Approved document G in table 3.1 gives all the pipe sizing for different lengths. But then has these other statements which slightly contradict each other. 3.58 The discharge pipe D2 should be at...

Thanks very much I think that looks like the right thing.

Hi all, I am trying to resurrect some PIRs flood lights on my house. There are two separate PIR, a switched override, and 5 flood lights. The PIR’s are wired in a very small gauge wire. This makes me think there should be some kind of controller with relays to carry the load somewhere in...

I think it’s probably a little too toasty for normal operation. Feels like 50 to 60 C. I’m wondering if the brushes need time to bed in and make better contact or something. rear bearing is certainly not as smooth as it could be, but it’s not horrifically lumpy or grinding. ill be on the...

Also if anyone knows of some bearing pullers with nice thin legs that would amazing…

Hi all, thanks for your input. i tested the armature. Axel to commutator, all ok Bars next to each other, resistance roughly the same. 180 Degree test, resistance roughly equal. The brushes seems ok. I had to replace one of the brush holders as I cracked it trying to remove /clean it. I...

Sadly don’t know anyone with an IR camera. Don’t suppose they have an app for that on an iPhone?

Hi All, Looking for some advice on fixing a sds drill. The motor was burnt out so i bought a new field and armature. Replacement vs repair was a bit marginal. After i stripped it down and reassembled it the base of the armature get really hot really quickly. I’m not quite sure why this...

Hi, I fitted a new soil stack with an access point using a double ring seal as pictured. However, it seems to be leaking from the lower seal? its been in place approximately 5 years with no problems. I think 5 year life is a bit short before something like this fails, or have i made the school...

Well dogit, Intergas and it’s 4 working parts sounds like just the trick. Less parts less to go wrong, are they any good?

Thanks gas guru. I see I am confused now. Thanks.

Found a gloosy video which shows the 2nd hex wrapped around the main hex.

I’m struggling to find a really good image, but will try and post a link later.

http://m.ariston.com/uk/Wall-Hung_Boilers_Combi/clasnetone And https://www.mereuprimul.ro/pics/large/14453_6127_prd.jpg I can’t find a an exploded diagram. But i think the secondary hex wraps around he primary hex