Recent content by alba2

  1. A

    Roof Membrane Questions

    Why would it be destined to leak more and more? From the description and photos do you think it has been installed incorrectly?
  2. A

    Roof Membrane Questions

    It is still within the NHBC warranty. Would that be worth pursuing?
  3. A

    Roof Membrane Questions

    Should the vertical wall membrane have overlaid the horizontal roof membrane when sealing?
  4. A

    Roof Membrane Questions

    What is the lifespan of alwitra?
  5. A

    Change internal (for outside light) single switch to a double switch for external cctv camera

    Bernard Green. You said: "is perfectly safe if done correctly". What do I have to do, to ensure correct fitting? Thanks
  6. A

    Change internal (for outside light) single switch to a double switch for external cctv camera

    I feel that I should further clarify matters to Winston1 re the double socket. Although it is a double 13 amp socket it is only being used for/and because the 12V cctv has a transformer plug with 3 prongs. The double socket will also be housed in an external IP56 box 8 feet above the ground...
  7. A

    Change internal (for outside light) single switch to a double switch for external cctv camera

    Hi FrodoOne Many thanks for taking the time to explain which wires to which contacts. I believed that was the method but needed reassurance, which you have provided.
  8. A

    Change internal (for outside light) single switch to a double switch for external cctv camera

    Thanks to both for taking the time to reply. I have attached a photo of the double light switch I will be using. To ensure I don't wire incorrectly could you please advise which wires ie from the existing single (to be replaced) light switch and wires to the double socket for the camera should...
  9. A

    Change internal (for outside light) single switch to a double switch for external cctv camera

    I am in a 7-year-old property. I want to convert a single light switch that currently controls a single outside wall light into a double, in order to switch an external 12v cctv camera. The exterior wall is clad and the current light switch is on the internal wall directly behind the existing...
  10. A

    Solution for some slight tile movement and grout cracking?

    Thanks a lot for taking the time to provide a considered reply to our problem. Weighing up your information and advice, as much as we like the tiled look, it seems that we may have to go in a completely different direction, so we don't want a repeat of the problem. In any case it is difficult...
  11. A

    Solution for some slight tile movement and grout cracking?

    Thanks to both for your replies. The only question I can answer is that I began to notice a few tiles lifting in 2019. It has slowly spread to others. It was a new build and an apparently highly skilled tiler laid the floor. Having said that I subsequently discovered that for the walls he...
  12. A

    Solution for some slight tile movement and grout cracking?

    We are in a 7 year old property with suspended chipboard flooring. The shower room is overlaid with plywood and screwed down onto the chipboard with really close spacing. The tiles are porcelain and the floor area is 2.6 sq metres. We can feel slight movement of about half of the tiles...
  13. A

    Need Help With Lighting Circuit Puzzle.

    Thanks, Bernard I should not and will not again, put my faith in voltage sensing pens. I watched the electrician using one during installation and wrongly assumed that they were kosher. I tested with a handheld meter, and all was well, ie no voltage. I had immediately jumped to the wrong...
  14. A

    Need Help With Lighting Circuit Puzzle.

    I am in a 5-year-old property, so all circuits are new. There are 4 x 240V 7W downlights in the bedroom. I decided to install a bedroom ceiling spotlight by means of a piggyback off one of the downlights. In preparation for installation, I switched off at the wall switch and the annotated...
Back
Top