Recent content by andemz

No, the cooker is on the other side of the board. I have called an electrician out and he is going to be coming back again tomorrow to do a full diagnostic on the electrics. I will post his findings.

Hi all, My wife was cooking tea earlier she had the electric oven on and the overhead extractor. When she turned the oven off all the sockets in the house went (Up and downstairs are on two separate sockets) The problem now is that when we try to switch and appliance on it just trips the...

purchased :lol:

I'm always looking for a deal if you know where i can get them cheaper from?

I was just planning the job. I'm actually thinking of taking the doglegs off, extending the 15mm pipe through the tile and then using the following http://www.plumbworld.co.uk/bar-mixer-valve-fixing-kit-4067-16361 to attach to my mixer bar. What are your thoughts on this?

much appreciated. I will do it right and take the tiles off

It is block

Hi Seco, that's exactly my point. This hasn't been fitted, so is there anything that i can do now, that the tiles are on. i.e. retro-fit. Something that goes inside of the shroud to give stability or something.

If by doglegs you mean the fitting that goes from the pipework to the mixer, yes, he fitted them as well, he stated that when he was fitting them he got as far back as access would allow.

Hi all, The plumber has fitted the pipework for the mixer bar, the tiler has tiled over and left the hot and cold coming through the tiles, i have come to put the shower bar on and the plumber hash't fitted a wall plate fixing kit so there is a lot of movement. the pipework is behind walls...

Hi all, Can you use normal waterproof tile adhesive on sheets of mosaic tiles. I m wanting to use mosaics to tile part of a kitchen. Regards Andemz

The boiler previously had a programable stat. The wiring has had to be removed and replaced. The wiring to the stat itself is not the problem it is at the other end at the combi. Within the combi you have the L,N, E and then terminal 3 and Terminal 4, both of which are black wires. When...

I know its a valiant, i will have to check the model number tonight. The thermostat is a time guard trt033 digital it is a new one regards

Hi all, I'm just wondering if you could give me some help with understanding the wiring on my combination boiler and thermostat. I have a supply direct from the CU for the combi, this feeds into a SFCU. There is a T&E to the thermo stat which is situated downstairs. The wire from the...