Recent content by andrew7043

Is there any point of fitting a cylinder stat as without any valves it won't be able to switch off water going to the cylinder and keep water going to the radiators? Would it not knock the whole boiler off? Would the boiler stat not regulate the water temperature going round in one loop?

Yes my system seems to be more like the first diagram. So i'm guessing it should work. As I can't switch between hot water/central heating all i'm doing is doing away with my programmer and replacing it with the heat link. All I wanted to know if that is possible as my system has no motorised...

I have a query about fitting the nest in my house. My central heating system is quite old and I cannot switch between hot water and central heating so on my old programmer when I switch the heating on I always get both working. So with this I have no motorised valves. The question I need...

No it's not attached.

Thanks everyone for your quick response. As there was a lot of different views what i can make of it is: The 30amp fuse (not mcb) seperate circuit not part of a ring, supply coming from the fuse board in my house which is not a rcd can supply a 40amp rcd consumer unit in the garage. I...

Hi all, I'm new to this and have a few questions about a garage rewire i'm planning on doing. The garage is supplied by a 30amp fuse in my house. I was wondering if the best consumer unit to get is 40A 30mA RCD. Would a 30amp supply be ok for this consumer unit? Also the garage...