Recent content by angelheart0604

The wires have been joined and taped all the way down to the lower double socket. I have had loads of trouble trying to get him back, god don't want to have to pay someone else now. What a nightmare. Seems anything that I get done always goes wrong!

OOoooh dear. thanks for your advice. I did not realise this is not how things should look. The oven is electric and the hob is gas. The oven is the Bosch Exxcel HBN53B550B Built Under Double Multi-function Oven. Uh I am just trying to get this sorted out so I can get this kitchen done :?

The chase above is where the cabling for the extractor is going. Yes all of the double sockets have been moved down, the capping is not in line as it needs to be fixed back in place before the plastering is done. He is coming back to connect everything up at the end I just need to establish...

I am having my kitchen refitted. Had the electrician around to lower my socket and install lighting cables etc. He didn't have time to finish the wiring for the extractor as was very busy so has told me what I need to do and that is fine. Trouble is, after he left I remembered that my new...

No nothing, I checked the box as I got it down from the loft which is quite ridiculous! That is a good idea to check out the resistance if I can find someone to do that for me! Thanks

There is nothing on them at all plus they have pink holders which makes it even more difficult to find! Not sure how to identify them?

I bought a fairy light curtain set for my daughter and have a problem. A couple of the bulbs had gone so decided to replace them (but not sure on the type as doesn't say on the box!) I had some others that look virtually the same so tried these but flickered and went out. Anyway noticed the...

Sorry just doing as the the other guy advised me so sorry to cause any confusion. Would the valve be consistent with no heat coming from the pipes coming out of the top of the boiler. Thanks

Is it possible that the burner is not igniting on this even tho I can't see that the pilot light is? The burner on light is illuminated at the front but the pipes going into the top of the boiler are not warming at all and no heat output from rads and no hot water. Pumps seems to be running...

None of the pipes at top of boiler are warm. Is it possible that the one I can see is the pilot and the burner itself isn't lighting up even tho the light on the front says burner on?

I don't know then! Anything else I can check?

The boiler is ignited tho (I can see the flame inside) and sounds like it is working totally fine...

There is one pipe coming from the cylinder into the valve, one out of the back of the valve and one from the side. None of them feel warm tho? There is W M H on the bottom with a little black switcher. It is currently on M. Sure it was on H earlier on. There is a little black switch on...

I have also not encountered any overheats on the boiler at all so would this seem to suggest the pump is ok?