Recent content by Anil777

  1. A

    Baxi solo 2 40pf burner keeps cutting out

    I just checked the temp sensor and I don't get a resistance reading from it. Is that right? Just doesnt show anything. He tested it yersterdsy and said it was fine 😕
  2. A

    Baxi solo 2 40pf burner keeps cutting out

    Thanks guys for the quick response. I called out and engineer today and he said could be the temp sensor so he checked it with his multi meter and he getting a reading from it so that's ok. He's ordered a new gas valve said its going to come tomorrow or on Monday :( . Though he didn't sound to...
  3. A

    Baxi solo 2 40pf burner keeps cutting out

    Hi all. My parents baxi solo 2 boiler keeps cutting out. The fan runs and the pilot light lights up. Then the burner kicks in for 2-3 seconds then cuts out. Was working fine couple weeks ago but they came back from holiday yesterday and it never fired back up properly. The pump seems fine...
  4. A

    Baxi 105he combi 80degrees flashing.

    It was defo the ch sensor. Left had side of the boiler on top of the over heat stat. I dunno if it was in a wet or dry pocket as I drained it down so would no. Tho I'm sure it was a dry pocket as it didn't seem to be in contact with water when removed. Heat paste? Erm no. What would happen if I...
  5. A

    Baxi 105he combi 80degrees flashing.

    Thanks gas112. It's not that I don't believe you just thought it would be in a wet pocket. Anyways got the part from a heating shop and he said its in a wet pocket so I just drained the boiler and fitted the part. Refilled and its working fine. Thanks for everyone's help. Saved me a for fortune. :)
  6. A

    Baxi 105he combi 80degrees flashing.

    I'm sure I have to drain the system down as its in the flow pipe. Also I just tested the thermistor and it read 14k ohms. Is that the right reading?
  7. A

    Baxi 105he combi 80degrees flashing.

    Thanks for all your replies. If the primary thermistor was at fault the hot water should be working ok? Shouldn't it? Thought the thermistor was in the ch flow pipe. ?
  8. A

    Baxi 105he combi 80degrees flashing.

    Hi. Thanks for the quickly reply. I forgot to mention that when I turn on the hot water the same thing happens. All the trvs and pins are ok. Pump seems to run but I don't know what it could be. :(
  9. A

    Baxi 105he combi 80degrees flashing.

    Hi all. I have a problem with a baxi 105he combi boiler. When I turn on the Ch boiler fires up and shows 30degrees light. Then after a few seconds everything cuts out and 80 degrees light starts to flash. The boiler restarts after a few seconds and fires up again the then the same problem. Does...
Top