managed to sort it thanks guys:)
it was the tamper switch not being made in the PIR sensor. The cover which had the spring thing on it to press the tamper switch in the sensor was not making!
Now that i have adjusted it it now works.
thanks for the help
Hi guys,
I have recently have had some building work done and the mains electric had been off for a while.
So the batt. went dead in the control panel. I replaced it with a suitable one and it was fine, system worked ok, although the reason I suspected that the batt was dead is that the...
right, found out how to disconnect the batt.
the voltage across the batt was 4.4 volts, think it should be 12volts.
what is the correct procedure for replacing the batt then?
many thanks
[/url]
Hi there i despreatley need some help.
I have had some building work in my house and the electricity has been on and off a few times.
the other day i went to set my alarm and noticed that the keypad was lit up but there was no power light on.
I pressed the buttons on the keypad and...