Recent content by atawn

I've been trying to wire up my new boiler (baxi combi duo tec 28) with my existing drayton 522 programmer and digistat 1 thermostat. I have one question I'm hoping you can answer: I've got power to the programmer and and boiler both off a 3A mains supply. Terminal 4 on the programmer...

Thanks kevindgas. The programmer and thermostat are already wired from the previous system (old back boiler). All I was going to do was remove the cable for old pump and back boiler and run a three core cable to the new combi from the programmer (as long as I wire it right!). To expand on...

I've just had a new baxi duo tec 28 combi fitted. My existing programmer and thermostat controlled both the CH and the HW. (using drayton 522 and digistat 1) Can I use these to control the CH only on the new boiler and have the HW run continuously (i.e. when someone turns the tap on...

I've just had a new boiler fitted (works off a mechanical clock) and am wondering if I can use the existing drayton lp522 programmer (with digistat 1 thermostat) with the new boiler if so how do you do it! My old set up was a back boiler and hot water tank with the stuff mentioned above...