Hi I have a draught from my upvc door down the lock side and it feels like the door needs some compression adjustment to move it tighter to frame when closed. Unfortunately the compression adjustments on the 3 hinges appear to be stuck and will not tighten or release without rounding the...
Thanks ABC - You mention only needing 6 posts would that be 1 in each corner and the other 2 in the middle?
Also if you don't mind me asking, what did you use for your flooring?
Hi I have been given a timber shed 16'x9' which currently sits on a concrete slab. As the only place convenient for me to place it is on a slope I was planning on building a raised deck using 4" posts and treated 6" x2"s. Do you think this would be strong enough for a shed this size?
Also...
Hi hoping someone can help. A radiator got knocked off its hanger around christmas time so had to drain down the system to repair pipework. At the time i put some system cleaner in and decided to drain it down today. On fillilng had a lot of problem with an airlock however system is now full...
Hi some of my radiators are sludged up. I have put some fernox F3 cleaner in the system and now the water in the small header tank is all dirty and cloudy. Is this normal? Thanks in advance
Hi thanks for the reply have had a quote that falls in the range but thought it was a bit steep as seems a fairly straight forward swap. But guess you dont get much for your money these days..
Hi can anyone give any ball park figures for installing an oil fired boiler. Just wondering about labour costs. its an external boiler which is just replacing an old boulter bonus one on an open vented system. Thanks in advance
Thanks for the reply's. The existing boiler was a boulter bonus. The vent is on the HW side. does that mean when the CH is on there is no expansion? There is 1 heater without a trv so will this act as a bypass
Wasn't sure about converting to a sealed system as the CH rads are on 10mm that...
MrMethane, sorry for the delay in posting back. I have lifted some floors and managed to trace the existing pipework as best i could.
I have tried to draw out as per attached diagram,
Thanks again