Recent content by BARRYG

  1. B

    UNDERFLOOR HEATING

    Hello I will be tiling our dining/ kitchen and hall floor soon. I want to install underfloor heating in these areas and am currently looking at heating mats/ribbon , to warm the floor tiles and take the chill out of the floor ,( not too worried if does not heat room up as a radiator would.)...
  2. B

    REMOVING RADIATOR PERMANENTLY

    I am removing non load bearing partition wall between kitchen and dining room ,which has a radiator on this wall. House is 4 years old , with a Potterton combi boiler , with overflow tank in loft, and flow and return pipes. The radiator in question has plastic flow & return pipes from wall...
  3. B

    SMELLY PLASTER

    Thanks Nigel , it has a 10 yr zurich policy , I will certainly ring them to fix it. Cheers Barry G
  4. B

    SMELLY PLASTER

    Everytime it rains there is a smell of wet plaster in a corner of a room downstairs. House is only 3 years old , cannot see any obvious holes outside - windows and pointing seems ok , although there is a gap for airbricks above the windows. Any advice much appreciated. Barry G
  5. B

    AMPS CALCULATION

    Thanks to everyone for all the replies. WIRING FIBRE OPTIC LIGHT SOURCE AND NEW SWITCH INTO LIGHT CIRCUIT IN LOFT USING 1.5m t&e and 20amp junction box. LIN = LIGHT IN LOUT = LIGHT OUT LS = LIGHT SOURCE SW = SWITCH Cable and junction box wiring (i think this right , have right info...
  6. B

    AMPS CALCULATION

    I am installing fibre optics in a bedroom ceiling shortly. Will wire the light source and new light cable (for a new light switch) into the light circuit , using a 4 terminal 20 amp junction box. Am I right to assume that if the lightsource is 50 watts and the mains voltage is 250 volts , there...
  7. B

    Steam Iron tripping RCD in various rooms?

    Have exactly the same iron problem ! Had a tefal iron and it blew the main fuse - then we bought a rowenta and this kept tripping the downstairs light circuit believe it or not ! Tried another socket in another room and it finally blew up yesterday - I thought it was a faulty circuit but all...
  8. B

    MIXER SHOWER PLUMBING

    Started looking into these valves - I am right in assuming that you can buy mixer showers with built in pressure balancing valves , and that you can also buy these valves as a seperate item ? I am looking to install a Triton unichrome shower tower unit where the hot and cold water is fed...
  9. B

    MIXER SHOWER PLUMBING

    Many thanks corgiman will get this valve. Cheers BARRYG
  10. B

    MIXER SHOWER PLUMBING

    Many thanks corgiman will get this valve. Cheers BARRYG
  11. B

    MIXER SHOWER PLUMBING

    Have a mixer shower on bathroom taps. Plan to install new mixer shower tower at other end of bath. The pipes to the bath taps are 22mm copper - plan to install plastic reduced compression tee in each of these pipes under the bath and run plastic 15mm pipes under bath , into stud partition wall...
Back
Top