Recent content by bellcrank

  1. B

    New Sounder with Scantronic 9800

    Thank you Handymanjo.... do I need to disconnect the mains or remove the battery in control box first? Or can I just get stuck in? The other thing is that my current box as no strobe, so does that mean I should add another connection?
  2. B

    New Sounder with Scantronic 9800

    About 5 years ago I was given very clear instructions here by handymanjo to replace a battery on our 9800 alarm system that we inherited when we moved in some 20 years ago, a procedure I have repeated again recently. I have now decided to replace the aging bell box with a Texecom odyssey 1E, a...
  3. B

    Alarm 9800

    Ok, I'll make a note of that... it was a case of out of site , out of mind. Now off to change the code. Thanks again for the advice
  4. B

    Alarm 9800

    No, but I wrote it on the log sheet in the control sheet. Didn't give us any trouble last night
  5. B

    Alarm 9800

    Yes, made it to Screwfix, got a battery and just fitted it. It seems to have done the trick, no sounding just lT code flashing. Reset it and it's back to normal. Old battery has September '99 written in the side!! Thanks a million Handymanjo
  6. B

    Alarm 9800

    Thanks for your prompt response, is there anything I can to to silence the buzzer until tomorrow?
  7. B

    Alarm 9800

    We inherited an alarm system (9800 is only identifier) when we moved here 12 years ago, and till recently it's functioned perfectly although we have never had it serviced. Now, we are getting bF fault code and internal buzzer every now and then on the contol panel located in our hallway which...
Back
Top