Recent content by Bikerboy58

Just saw this better explanation from 'MIGEM' on another post relating to low flow....... Id guess if you remove the tap body, you will find that the washer is worn and flat. which lets the spindle wind down further than it should. That exposes too much of the spindle 'O'ring and lets water...

Had similar problems recently. Idiot step-son was cranking hot tap down too hard and the jumper came out of the end of it's thread. Reassemble with instructions not to be so heavy handed in future, no probs since.

Hi All, I've just had to clean out the filter in my toilet cistern float valve and in the washing machine inlet. We seem to be getting a lot of limescale and other stuff coming through the pipes and I am concerned about potential damage it may cause (apart from the reduced flow rate). I have...

Hi all, I'm new on here so be nice to me for a day or two at least :lol: I've browsed through the info on here and othe sites about AAVs for domestic soil/vent stacks. Apart from the debate about whether or not people like them there is contradicting info about where you can put them in...

Wannabe plumber