Recent content by brett1976

The same info I found when using google, not sure where the coding resistor info is from but defiantly helps me more if it is that is my problem and not just the faulty loom suggested in the manual as that doesn't really tell me much more. The fault didn't have any other intervention beforehand...

Hi there, I was hoping there maybe one or more of you kind chaps out there that maybe able to help me please. Have the following fault F.43 on my Vaillant Turbomax Plus 824e. Been looking around and it maybe down to either a faulty or incorrect wiring Loom, how true this is I'm not sure...

Back again , boiler still playin up this morning but what I did find is if I reset it and tried the ch it would shut down each time but when I turned ch off and tried the dhw a couple of times ,eventually the boiler would fire up and be ok then I could turn the ch and this then works fine also ...

Not sure what I did if I did anything that is and screwed it back together and it fired up and is now working I'm not sure what that tells me because I didn't really do anything so I'm still baffled . I think I'm gonna look into that boiler you recommend .

Thanks for gettin back to me , can't see any obvious signs of damage on the PCB , my pilot does also ignite but goes off after so many seconds . I put it down to a sensor at 1st as the problem happened a few times leading upto today but I was able to reset and the boiler worked fine for the...

Can't find any dry solder joints , relays not sure what these are but the clear boxes have no sign of burnt marks, The boiler pilot light ignites for both ch & dhw but decides to turn off after about 6 sec's then on comes the permanent red led shut down :( . Still no wiser :((

Hi I'm no heating engineer. Anyway my problem is that my boiler will not ignite for either dhw or ch . Tried Reset green ,ignition led flashes for a few seconds cuts out then the red led boiler (shut down) comes on , it sounds like the fan/pump starts , no sign of any clicking noise . Any help...

once i got home and placed a new bulb in , it was still in working or no buzzing etc, the CU is a Clipsal and the mcb is 6a if this helps me ? :(

@river hi mate i havent had chance to change the bulb as i left to go work but the buzzing had stopped after 5minutes when it had 1st blown so irl have to check once im home with a new bulb not to sure of wattage etc i forgot to mention im no electrician.its on a two way circuit where 2...

Hello. im after some advice please, i woke up this morning went into my kitchen and turn the 12 50w spotlights on , of which one of them blew straight off and tripped out the mcb , i then flicked the switch back on. this in turn caused buzzing noise from the unit , i flicked the switch on off...

thank you very much Fox for your info ,

i did but at the time i had the underfelt on already and most of the tiles , this was over 2 months ago and since then this problem hadnt arised so its only just come on since the weather has got colder

well im after some advice, ive not long put a new roof on my house , for some strange reason i have just got what looks like and feels cold damp patches just in the corner of one room that is the outside corner wall as i live in a semi detached. ive looked up in the attic and its bone dry...