Tried a wash with the machine pulled out and was going great guns for about an hour, then bang lights 2&4 flashing again!! Time for an engineer or should I check for a blockage around where the waste pipe connects to the machine?
Just to add, after reconnecting the pipes. I ran a spin cycle and it was fine. Water leaked from the front door during a D spin-no lights flashing during this.
Retightened the pump and the filter again as I think they were loose. Wife tried it this morning and seemed ok but water now looking from the door. Idf the waste kinked or sink spihot blocked, how easy to reolve?
Thanks again!!!
Rocks, lights 2 and 4 now flashing, checked the code and says pressure pipe full!! Any ideas? Thinking I may have not reconnected the filter or the pressure pipe properly!! Thoughts??
Cheers Rocks, finally managed it and cleaned out the filter!! Seems to have worked and just testing it now. Thanks for all your help, your a star!! Having a beer to salute you!!
Have disconnected the pressure pipe but the filter cup is held fast with a plastic clip at the top of it-is that the jubilee clip? Frightened in case I snap it off?? Can I clean the filter from where the pressure pipe was attached?
During a D Spin cycle, the machine stopped and the 2nd light(reduce creases) and the on/off light started flashing rapidly. Have tried turning off at wall but still flashing when turned on again.
Any ideas? PCB board only replaced two months ago.
Thanks in advance,
Brian