Recent content by bringit

Thanks for the concern - had thought there may be an expert on here that would have seen the fault before and could offer advice rather than fear, before I go down the expensive route. There will be no deaths here, water is not above any bedroom. Anyone with some advice as it would be...

Vented CH system Ideal Classic boiler (15y old) CH header tank in loft I have a strange problem where I intermittently have very loud banging (kettling) from the boiler, loud noises from the loft header tank which is steaming with boiling water coming down the overflow into the header tank...

Well I now feel a bit stupid! It beeps when it is first touched, so I took that as the "handshake", but yes you are right. It needs to be held on for 5 seconds. After all the complicated stuff (imo) that I have done with the system, I got stumped on 5 seconds!! Thanks for your help.

Due to the help received on this board I am basically finished with my Galaxy alarm install. There is one thing that is bugging me - I have keyprox set up and they unset the system ok, but I can't work out why they won't set the system. I am in code 42 - users - keyprox is ok with digits - 8...

Forgive me if I am wrong, but they have joined the flow and return together. So I have one for leave as it is, and one for cut it and cap it (both suggest replacing the t's). If I don't replace the T's , should I leave as is, or cap off - builders have done this and planning to plasterboard...

Can you help me understand why we need to cap off the flow and return and not have it like this? Thanks

Hi, We are permanently removing a radiator and would like advice on whether each end should be capped off or whether the pipes should be joined like the photo below? It has currently been done per the photo, but I can't work out if this is right? Any advice would be great, thanks

Hi, I am fitting a full AG6 bell box at the rear of the property to replace a dummy box, but was planning to use the internal battery and LED to have a flashing deterrent at the rear. But I cant work out how to do this, or if its even possible? All instructions point towards needing the 12v...

Hi All, I have purchased new Galaxy kit off ebay and other stores and will be attempting a self install/replacement from the existing wired alarm system. I have Galaxy G2-20 panel, bell boxes, PIRs, and Key pads. I am pretty sure I need to do the following and have the installer manual...

thanks Dan, would you need to know any other info that I have not covered to be sure of the answer?

Hi, i am in the middle of securing quotes for the installation of underfloor heating in a new extension, however I have had two different heating engineers round, who are saying different things, so naturally I thought of turning to the internet for a definitive answer!! I have a boiler in...