Hi all
I am looking to add a new rad to the spare room and have located a manifold under the floorboards. All the existing pipework to the rads is in 10mm and hence all the ports on the manifold are 10mm. Having looked closely at the manifold I am confused about the flow and return set up...
I have installed a short length of worktop in my utility room and I'm left with a bare edge. I have a strip to stick on to this.
What is the best glue to use and what is the best way to trim off the edges to get a neat finish.
Many thanks
I am installing a new macerator in newly constructed downstairs toilet.
I need to take the waste out to a small courtyard where the main drain is. My question is, can I plumb my macerator waste into the plastic kitchen waste pipe already in the courtyerd? Not sure if I could do this or if I...
I have a very large and very old water storage tank in the loft which needs changing. This only feeds the hot water tank below and nothing else. This is a small terraced house with one bathroom and 2 adults. I would like to fit a smaller tank. Any ideas which size would best suit my needs?
Many...
I have taken down an old external cast iron soil pipe as it was getting to be unsafe. I am going to install a new plastic soil pipe. I am left at ground level with a glazed bend that has a lip on it. Can I simply insert my new pipe into this and concrete the gap or is there some sort of fitting...
Best advice for laying copper pipes in concrete please.
Need to move a radiator about 2 metres to allow new door access. Copper pipes in concrete and will need to dig channel to get them out of the way.
Many thanks.
Sorry photo not in last post. Hopefully here it is.
Just to recapp, I was curious as to what the small cylindrical item was below the pump. What does it do?
Many thanks