Recent content by bureaucrazy

  1. B

    9 X 2 3/8 inch diameter (60mm) roller cage?

    I have a 9 inch long roller cage but the diameter is 2 3/8 inch (60mm). All the paint shops only seem to stock 9 X 1 3/4 inch diameter roller sleeves which seem to be the standard size. Not sure where the roller is originally from, possibly crown trade shop but I cannot find the replacement...
  2. B

    One for the Baxi boys.......

    Answer The problem was that I didn't let it cool down long enough before disconnecting the power. The residual heat in the heat exchanger caused the water that was no longer being pumped to exceed the maximum permitted temperature and trigger the fault condition. E125 means water temp...
  3. B

    One for the Baxi boys.......

    Hi, I have just had this same problem. I switched my baxi platinum boiler off on the panel because I needed to turn off the electricity supply to the house. The boiler had been firing the central heating before I switched it off. Before actually turning the off switch, I turned down the...
  4. B

    Push fit waste permanent or not?

    I am not familiar with push fit waste system but need to fit a new bath to an existing old push fit waste pipe. the final length of pipe is black with the rest grey and goes into a push fit connector. when i twisted and pulled the black pipe, it came out quite easily. is this normal? i'm worried...
  5. B

    Waste pipe compatibility

    I need to replace a shower for a bath and will have to extend the existing waste pipe and fit a new waste. i heard that not all manufacturers waste pipes are compatible due to variations in diameter. i am worried that i wont be able to put new fittings on the old pipe and it cannot be easily...
  6. B

    Sash window repair - epoxy resin?

    I need to restore a neglected sash window. There is not much actual wet rot, just a bit in the corner that I will fix with a small splice. However, the cill is in a bad state. It's not rotten but has many small horizontal splits in the surface from water expanding inside over time. The top layer...
Back
Top