I have a 9448 installed roughly 15 years ago - recently one PIR has started to glow red continuously
Can I simply replace the PIR with a new one (no obvious spiders etc infront of sensor) without opening the box? or is there likely to be another fault
I do not have the service manual only the...
I have a understairs cupboard which has the walls painted with synthaproof + I'd like to paint over with a grey oil based floor paint.
Is there a way of preparing the synthaproof/bitumen to stop it leaching through into the floor paint?
would a coat of pva do or is there anything better...
I have 2 stud walls made of 18mm wbp ply for the new shower. It has been suggested to me that I coat the bottom edge/back of these stud walls with cementone SBR before fitting to the tray - I was planning to lay these bottom edges on a bead of silicone (between the tray and the ply). will the...
I have 2 stud walls made of 18mm wbp ply for the new shower. It has been suggested to me that I coat the bottom edge/back of these stud walls with cementone SBR before fitting to the tray - I was planning to lay these bottom edges on a bead of silicone (between the tray and the ply). will the...
dont have any instructions unfortunately but it is a stone tray not resin
have some old cementone sbr - is it worth adding to the mortar mix to allow a bit of movement?
any thoughts on which is better to bed a stone tray; I've only fitted them with mortar before, but was told it's now common practice to bed on silicone - if so, how does one do it?. is it a case of using ordinary silicone and covering the whole of the bottom of ther tray, or just at the corners...
does liquid ptfe work better than tape - I am concerned there may be some leakage around the spigot in the bsp female fitting/would liquid be a better bet?
can any one help?
I am putting in an aqualisa quartz with fixed head - 3 questions....
I have run 15mm copper from the pump to the recommended 1/2in bsp female fitting which is secured to the wall - do I need to wrap the spigot (used to mate up to the shower head) threads with PTFE tape to...
given it's a warix flange, is that good enough for the hot feed to the new shower pump (1m away via 15mm copper)? another question - there isn't a separate cold feed from the loft cold tank; given this seems to be a good idea (?) do folk recommend putting in a 22mm cold feed all the way from the...