Recent content by cammy2207

Thanks guys. I've just had a look at your suggestions. They all look like they would do the job. I have a set of flap wheels, similar to the sanding drum bit, would that work? I also have some round and flat rasp files. But also the router and rasp drum also look ideal so I'm going to have to...

Hi all. It's been a while. I have solar decking lights that I measured the circular protruding base at 60mm so I bought a 60mm hole saw. The holes are just not big enough, literally 1 or 2mm. What is the best tool to use/buy to expand the diameter slightly?

To add, to get the multi point locks to retract to the '90%' point takes very little effort (as you would expect), it's that last bit that takes so much downward force on the handle

Well!.... I haven't but it seems not to be sticking, more like the handle must be pressed down very hard to get the locks to retract that last little bit. However for the sake of ticking boxes, I will give them all a spray.

Multipoint locks won't retract fully, meaning door won't open, unless excessive force is applied to handle at lowest point. I can open it but my wife and children are now really struggling. After lifting the handle to activate multi point locks, they only go back in by 90% when handle pushed...

Very quick and informative guys, thanks so much.

Hi all. If I changed my 1700 single end bath for another 1700, are the wastes a standard length or is there a chance they will not match up with the existing waste pipe under the tub? (Or is the final fitting a flexi hose like the overflow?) Thanks

How could I lower the last pipe on the way out. The welded sealed one? Could I cut it and reattach it somehow making it attach to the trap lower?

@terryplumb what joint exactly would that be that you find suspicious also mate? Which one is 'the waste'?

Hi all. I have a 1 1/2 kitchen wash basin. As you will see in the pic, I have a leak from the part that is circled. I have tried boss white around it but the water is coming back the way I guess. The join is not tight as the thread doesn't seem to tighten up properly around the inner pipe for...

Works a treat. Thanks to all. Cheers

Here's the instructions I got with the stat... Just to make sure before I go ahead and wire it in, its L - 4 N - 3 SL - 2 L bridged - 1 ??? Thanks

OK, I'll go with that. Post back with results in due course. Thanks to all.

@Madrab I have the GC version. Is that not the one that needs bridged and not the GB version? As per your last post.

Hi It is the GC pic in madrabs post. So it's a bridge from 4 to 1 then? A few conflicting ideas here. My current stat is the GB pic. It is for underfloor but it works fine with the boiler, and as @ajstoneservices services says, it is the switched live to L1. Any defining answers?