Recent content by cjb19711

After measuring the kitchen myself i found that the 4m width would of ended up 30cm from each wall (L shaped kitchen) Instead they cut some off the edge on the **** so a joint was then required, so amongst other probs when straight edge of units is in will see the zig zags are way out of square...

My mother had a vinyl floor fitted yesterday, i know with stuff perfection may not be achievable but this stuff look horrendous! Is it possible to trim it so it fits flush to skirting? This stuff seems lipped up as if its a few mmm too big. Bubble along all the edges,had used spray adhesive from...

Thought of that but joists are all over the shop spacing wise. Cross fitting them could get centres dead on so minimum cutting of plasterboard. Dint mind loosing a bit of height as left with a 60mm gap at bottom of walls if i board them at current height. Just cant see much info anywhere about...

1920’s house renovating the lounge and after removing ceiling have found the joists to be all over the place. After some reading up have decided to go the route of fixing up some cls timer at 90 deg to original joists, starting at low point and packing them out level. Would 36 x 63 cls timber be...

Have stripped my lounge to bare brick,new floor /joists fitted with soundproofing under them. Next job is to try soundproof wall to my noisy neighbours house. Have been looking at options and decided on rockwool rwa45 and either 1 or 2 layers of accoustic plasterboard. For this i intend fitting...