Recent content by click

  1. C

    Fuse Box trips out when i turn my grill on ??

    Hi i have a Newworld built in oven with grill. The problem i`m having is that when i turn the grill knob for the grill to come on it trips out my main fuse box leaving me with no power in the house atall untill i turn the knob back and reset my fuse box, my oven works fine its just the grill. Do...
  2. C

    loosing pressure when frost protection starts

    Hi i have a glow worm 30cxi , which works fine and runs with no problems atall untill it gets to freezing outside and the frost protection kicks in, its then that i loose pressure and it goes down to 6 bar and the cental heating doesnt start. when its fine outside the boiler runs for months...
  3. C

    30 cxi no central heating ???

    un linked the roomstat but still the same, i`ll ring glow worm tmw thanxs anyway , regards paul.
  4. C

    30 cxi no central heating ???

    Yes its turned up full, its totally baffled me
  5. C

    30 cxi no central heating ???

    Hi i have hot water on my glow worm 30 cxi, but when the central heating starts up , it runs for about 20 seconds then stops, there is no fault signals and the pressure is fine, any ideas thanks paul
  6. C

    Cant stop a leak ?

    Hi ive got quiet a bad leak coming from the joint on my flow switch on my glow worm 30 cxi, i have replaced the O ring twice but the leak is still there. Are the O rings on glow worms a special size or am i just doing something wrong, the switch itself looks ok on inspection, any help would be...
  7. C

    Glow worm 30 cxi

    What is a Actuator ??
  8. C

    Glow worm 30 cxi

    Also which i forgot to mention is i replaced a o ring and a small amount of water went near the electric board, i know this is supposed to be a sealed area, but if any water got in could this have caused the problem ??? thanks again
  9. C

    Glow worm 30 cxi

    Hi i`m having trouble with my cxi . NO matter what the wall timer is set to ,even the off postion the centrel heating kicks in , unless i turn the temp knob to zero. So i`m unable to set a on and off time because as soon as i increase the temp on the control it kicks in straight away, i think...
Back
Top