Hi can anyone give me some advice I have finished my annexe :
Single storey total all 4 sides 84m square what sort of price can I expect to pay to have it pebble dashed. I am in Kent if that makes a difference.
I do have one price but he came back to me 3 times in minutes changing it, I also...
Hi yes we needed a shower pump but now it's almost a pressure washer effect, where can I get a restrictor as it sounds the quickest option if not expensive.
Thanks for the advice
hi I have just replaced the shower pump on my shower and as we had re modelled the bathroom. at the same time I changed the shower to a low profile one ,now when we have a shower its can overflow the tray. What can I do to improve the water draining away, the floor is now tiled but it had a...
Hi I have seen lots of posts on removing a radiator permanently from the system but I am not sure if my system is a 2 pipe or 1 pipe system. I want to remove the kitchen radiator completely and take the pipe work back under the floorboards and either cap or join it together.
we have a combi...
Ok thanks for the info maybe me checking at 6am this morning missed a connection and it is 4. I will measure the distance and work out the bar pressure. So if I am right the lowest one I could buy to fit my system if 0.1 bar would be a 1 bar or 1.5 bar ? is that right. do you go to the next...
Hi can someone offer some advice on the following :
my Shower pump packed up last night so at present don't know if its simple such as a fuse or a complete replacement. I have a combi boiler ( LPG Greenstar ) but also a hot water tank in an airing cupboard and a cold water tank in the loft...
Hi Tony's thanks for the reply, yes my consumer unit has the cartridge type fuses. I removed all and checked everything for continuity with an multimeter. My control panel is powered by a fused spur 3a which I believe is common.
hi thanks for the reply, when something goes wrong you grasp at straws, so my logic what has changed etc... etc...
I removed a rad , and water tripped the system hence my questions. and if you look I did after stating my question re pressure then quote back pointing out it could not be pressure...
should have said this is a vented system with a header tank in the loft, Have just checked that and ball valve is working ok and tank is at the right level.
Also noted on some boiler instruction paperwork that this type of boiler e.g. vented deals with pressure automatically.
Hi can someone offer some advice on how to fix please,
I was in the process of changing my bathroom radiator for a towel rail and some water went through a floorboard onto a light switch below and blew the electrics. I waited and dried everything out and all seems fine now but I have no power...