Recent content by Cluelesstotally

Thank you for the answers much appreciated

Ok thanks, so: - is that the main heat exchanger? - is it OK to continue to use topping it up until I can get someone to look at it? - does anything else need replacing at the same time or just theeexchanger? Thanks Becki

Ok thanks, so: - is that the main heat exchanger? - is it OK to continue to use topping it up until I can get someone to look at it? - does anything else need replacing at the same time or just theeexchanger? Thanks Becki

Lots of page views but unfortunately not many replies, anyone know? Thanks Becki

Hi all, further update, last night I repeated the test of turning the CH flow and return valves off and again turned the boiler off with the on/off button on the front but this time I diverted the condenser outlet into a bucket to see if any water came out with the above valves closed and...

Thank you for replying, so a heat exchanger failure would still have an impact on pressure with the boiler switched off? Thanks Becki

Hi all, Over the last couple of days my Worcester bosch Greenstar 37cdi has been losing a lot of pressure. I have been topping it up during the day but it loses all pressure over night. I searched through previous posts on here and have checked the following as a result. - No leaks...

Ok, many thanks

Hi all, Just had a new solid oak staircase installed today. I don't plan on carpeting it at all, but it will only be walked on with sock or slippers, never shoes. What am I best using to protect it while changing its appearance as little as possible? I want to treat it tomorrow morning and my...

Thanks I have ordered the 1A pack of these as the online engineers manual says they are 20mm http://mobile.maplin.co.uk/module.aspx?moduleno=451 The middle fuse on rhs is the loud speaker fuse from the online manual so yea I agree I need to test/change that one. I am guessing its not...

Ok great thanks I will try Maplin. How are the fuses connected are they soldered in or just push in ? Thanks again Becki

Thank you very much for the reply. Yes that's correct, when I set the system all zones light on the control unit and non of the room sensors have any lights on them. So, am I right in thinking that it is F2 and F3 since the in house loud speaker doesn't work either? Where do I get 1A quick...

Hi All, I need your help again please this time with an alarm issue. I have a Accenta G3 alarm that was installed by a company for the previous owner of the house. I have been doing some decorating this week and took the internal siren and one sensor off the wall but didn't disconnect either...

Fantastic, what a star, thank you for the taking the time to find that. I'm guessing you agree with that, I thought Wikipedia was full of rubbish though, from jokes on tv etc, is it a reliable source I've never been on there? Thanks Rose

Hello, I have recently had the electrics rewired including the lights. In one room I want to replace the ceiling rose (which is in downstairs loop) with a modern light fitting. The new light just has a 3 block connector L, N, G, but the ceiling rose has 3G, 2N, 3L, 1L, 1N with L sleve, plus 2...