Recent content by Cookiez

Hi everyone. Would anyone be able to shed any light on a problem I'm having with my heating. I have a glow worm Micron 30 wall mounted boiler in the kitchen. I have a hot water tank upstairs in a cupboard. Cold water tank & expansion tanks are in the loft, both are full & valves working...

the interlock locks the door ok. The machine had a little water left in when it stopped. There is no sounds at all from the inlet vlaves, when set to rinse or wash. the only thing the macine will do is drain. it will do this even if the door is open. I did order a new machine...

Thanks for the quick reply Fido. If the interlock fails, how will I know what 2 wires to connect together. Ta Cookiez

Hi Everyone. I have a whirlpool AWM1400 that stopped mid cycle, before it started to do its 1st rinse. I have had a general poke about, There is nothing stuck in the pump. The belt is still intact. I managed to set it onto a drain & it drained no problem. After it had drained, I looked...

Hi there. I have done the same as your asking. I used a jigsaw with a worktop blade. You can get to most of the worktop, you will not be able to go right to the back. I used a sharp chisel and gently removed any excess worktop. Go steady with the jigsaw, don't push to hard, let it do...

Thanks for the prompt reply Fido. The machine I was considering is a Hotpoint Ultima WD860P Its a washer / Dryer. Its my 1st Washer Dryer, Are there any things to do differently on a Washer / Dryer than a normal washer. apart from the obvious. one thing that attracted me to this...

Hi. Is it worth considering a washing machine that has only a cold fill? I spent ages looking at loads of different machines, decided on one with everything I need, Delay Start, Quick Wash & Quiet spin. Only to find that it was a cold fill only. I then looked round at a few other...