Recent content by Dan9471

Recently our back boiler failed it's yearly service due to a carbon monoxide leak, this was traced to the flu and a quotation was done to replace the old flu with a new one. since having the new plastic flu installed I have today just watched an episode of dragons den which showed a grommet...

Hi Dilalio, Thanks for the heads up :)

Well thank you guys for all your reply's, i appreciate the advice, Flameport i can see clearly your a very experienced person on here with over 5000 messages and i thank you for your advice, but i did want to say in response to your last comment about how hard is it to hang the radiator, i have...

Evening all, I have taken the decision to change my bedroom radiator, its only a single type 11 currently and just is not producing enough heat. I think imp going to op for the type 21 not 22 as the larger one will be overkill and stick out from the wall 107mm as its a Barlow from screw-fix...

Sorry for the delay in getting back to you all, just been so busy at work, well i got the old one off in the end, took some brute force and off it came, the funny bit is that dam clip fell behind the cupboard below when i was unscrewing it (probably the best place for it!!) once i got the old...

Hi guys the new tap only arrived today so ill be doing it tomorrow, thank you for all your advice, ill be submitting pics asap on how i get on.

Well the new tap arrives tomorrow so ill be stripping it down then, ill take photos as i go to show you how i get on, i did think like some of you was it installed before the sink was put in place. If i do have to take it all out its going to become a big job as its a large sink and the other...

Thanks, ill give it a go and let you know, did you mean unscrew the tails from the tap itself as i find it very hard to get to the ends right up in the base of the tap?

Hi guys, Today i have set about going to change my mono-bloc kitchen tap. Once i cleared out the cupboard i came across this odd looking fixing holding the tap to the sink, it would seem i now have to remove the tails before i can unscrew this fixing, i have looked for this type of fixing...