Hello everyone
I have a small leak in my pit. It's right at the bottom where the wall meets the floor. I have (incorrectly) tried fixing it with Sika waterproofer, but the tiny drip keeps coming. I followed the instructions to the letter, but think its just not the right stuff for this wet area...
Hi, thanks for this. I will get someone in. No point in asking for advice and ignoring it. One thing getting covered in a bit of water, another thing going up in a puff of smoke.
sorted :)
I didn't have the clip forward enough to grip on the shoulder of the small pipe.
Many thanks for your tips, they proved invaluable. Now to sort out why its cutting out when starting up :(
By the sounds of it, its the detection electrode not picking up the flame. I'm hearing a click...
I'm sure its the right way round, but to be sure, I'm guessing the wider end goes on the diverter valve, sitting in the recess, with the smaller bit on the pipe. I'ts been driving me nuts. I thought I might have missed a washer or some thing.
see photo of the thing on the bench without pipe in...
Hi, sorry to resurrect an old thread, but I have a related issue. I've got the pipe out, replaced the bits in the valve, but cant get the spring clip to hold the pipe in place. Any help would be most appreciated. Thank you
Hi All
I am in the process of replacing my faulty 3 way valve with a repair kit. All was going fine until I came to put the retaining clip on the small pipe that goes into the back of the 3 way valve and runs round the back of the secondary heat exchanger.
I can see that it clips on the valve...
Hello all. I'm new to the forum, but have been lurking in the background picking up very helpful tips, while I fix my Ariston boiler which is giving very luke warm water. I've narrowed the problem down to the 3 way valve (i think), as when I tested the system by running the hot tap, the...