Recent content by Dave99199

Just noticed the cooling phase cycle indicator (fan type symbol) also flashes when this happens.

Hi, I'm looking for help with our John Lewis Tumble Dryer JLTDH16 showing error code E60 whist drying. The machine ate the door seal and after replacing it the E60 code went away. It looks like the code points to the door switch and I wonder if fitting the new seal pulled the door tight for a...

sorry for the late reply. no joy with those suggestions unfortunately. Now wondering if the water is too hot causing an issue with the T bar thermostat as the water in the taps is very hot. The local water pressure also seems to increased recently as there are a lot of toilets in the block with...

Hi, We have a pulsacoil a class thermal store supplying hot water to a shower with a T bar mixer. The shower is no longer providing hot water from the shower. The pipe feeding the mixer is hot the T bar has been replaced It stayed hot for a couple of days and then slowly the temperature...

Alarm is fixed and firmware upgraded to 5.04.01 via the cloud service. Sorry one last question. I noticed there is a SmartCom upgrade to v3. Is that worth going to? I'm currently at V02.02.02.

Fair play. Thanks again :)

Thank you both that makes sense B being before Y! I'll cut the earth wire off the old PSU and connect to the mains earth. The new one was sent out to address the recent PSU issues. Prior to powering it down I had the following messages on the keypad so hopefully this will will fix it: mains...

Hi, Please find the 2 PSUs pics attached. AUY - original. AUB - replacement from Texecom.

Hi, I have received a replacement PSU for my premier elite 24 poly alarm. The old PSU (HAC1000-5 / serial AUY) has an earth wire connected between the choc block and the psu and the psu and circuit board. inside the PSU the 2 wires are connected to the same solder pad and one side of a ceramic...