Recent content by davecooper

That link seems to suggest it could be the case, especially as he did specifically ask whether we had any such system. I'll leave it for any new incumbents to sort out if that's what they want.

Just had an EPC rating done on the house due to us wanting to put it on the market. It got a rating of D with the potential for a C. However, there is nothing to say what would need to be done to bring it up to a C rating. An identical house in our road was given a C rating recently so not sure...

Will go with your suggestions for Multifit/Surefit. Will replace with solvent weld once the job is finished. Thanks.

Had a new bathroom external waste pipe fitted a couple of years ago which uses welded fittings. This runs across an area of wall rendering that needs to be replaced. I was going to cut the pipe and temporarily fit one or two push fit connections so that I can easily remove and replace the pipe...

Thanks. I will mention this to the installer. Come the day, I will see what my local companies charge for EV charging installation. I am with Octopus but they are not my favourite people at the moment. No award winning customer service for me, but that's another story.

I am about to get some quotes for replacing my ancient consumer unit. The chances are I will be considering an EV in the future but will not be getting a charging point fitted until then. Will this have any bearing on the type of consumer unit I have fitted? I imagine this is something I will...

Thanks for that. It looks like what I was looking for. I have seen others but the quantity wasn't great. Reviewers said that many were tester sized and would not treat a complete wall, floor etc. I will try the syringe method as you recommend.

Actually trying to sell the house and as the tiles go under everything, doing the complete floor would be a a longish job. I just don't have the time to do it properly. Sanding the grout actually brings it up very well but I need to seal it straight after. Finding a clear sealant also seams...

Can anyone recommend an effective grout paint/reviver for floor tiles. Current grout was mid grey but now very stained so want to colour the grout black as much of the kitchen is now black.

It's quite a rough grout and seems to trap grease and oil etc which just makes those areas look dark. I think I have found something though. Thanks for the reply.

Just had a go at getting the light grey grout between my kitchen floor tiles clean again. I tried lightly sanding a section of the grout and it has come up a treat. However, before I consider doing the whole kitchen, I want to seal the grout afterwards. Any recommendations for a good brush on...

He isn't too keen on touching anything (not his thing!). We are visiting next week so I will have a look then. Might order a new breaker just in case.

The left hand breaker was actually on the good circuit, it was the right hand breaker circuit which had the problems I believe. Anyway, as you have advised, I will suggest he looks at seating the LH breaker correctly and resetting it. i will also suggest a complete reset of the supplies as you...

Seems a strange one this but someone might have an explanation. Got a text from Son in Law this morning saying he had lost all of the sockets on a downstairs circuit. He said the breaker for the circuit was still showing ON. He lives 200 miles away so no way I can pop round to have a look so I...

Decided to take a few inches off the bottom of a bathroom roller blind due to some mould marks on the blind. Done this before for roller blinds but have never seen the type of bottom rail fitted to this one (see photo). After the struggle I had getting the rail off and cleaning the glue off, it...