Hi
I've got a tatty kitchen Worktop that needs touching up but I need some advice.
1 what has the surface been treated with? Oil , stain, varnish?
2 what can I do about the mold around the taps
3 some of the wood is sound and some is almost bare from wear and tear. Can I treat both the same way...
Hi,
I am hoping for a bit of guidance on my central heating system - ive never been able to get the heat out of it I would like and I dont understand the system as a whole.
We have a number of radiators, a timer with 2 switches, one for hot water and one for heating and a gas boiler with a...
would you expect there to be an olive with a prestex joint? I think my problem is there is no olive.
and do i need a special prestex olive? if not what kind do i need?
how would i go about doing that. I am only a humble layman who has leak and is learning plumbing very fast :D
water continues to flow when it is switched off. Does that sound fixable?
sounds like i should see whats wrong when i take it apart
Hi,
Wondering if anyone can help.
Ive got an old 1/2" system but have a leak.
One of my options is to fit a blank nut.
Is it ok to fit a 15mm blank nut to a 1/2" joint?
its copper. just looked at the stop tap and its got 1/2 stamped on it but its bigger and chunkier than the 15mm ones ive seen.
i did think the pipe size looked about right but ive still got a stop tap thats 3/4" too short.
Plan C is to put a blank nut where ive got a leak as the supply is...
Hi,
ive got a leaky pipe (see other posts) but am looking to get a new stop tap.
how do you work out the size of a pipe?
(i measured the circumfrence which was 53mm which gave me a diameter of 17mm which made me think i need a 15mm stop tap. bought it but its length is 3/4" too short)