Tatty kitchen worktop

Joined
2 May 2012
Messages
19
Reaction score
0
Location
Bedfordshire
Country
United Kingdom
Hi
I've got a tatty kitchen Worktop that needs touching up but I need some advice.
1 what has the surface been treated with? Oil , stain, varnish?
2 what can I do about the mold around the taps
3 some of the wood is sound and some is almost bare from wear and tear. Can I treat both the same way?

Thanks
 

Attachments

  • IMG_20171027_134243.jpg
    IMG_20171027_134243.jpg
    704.1 KB · Views: 203
  • IMG_20171027_134337.jpg
    IMG_20171027_134337.jpg
    580.5 KB · Views: 188
  • IMG_20171027_122618.jpg
    IMG_20171027_122618.jpg
    465.3 KB · Views: 191
Sponsored Links
Thanks. Finally got round to working on this. Can any one identify the type of wood it is from the photos
 
Need photo in natural light at about 5 ft from top , close ups not very good.
 
Sponsored Links
Iroko?

Mind you the worktop looks like it has been made out of planks of wood (possibly even floorboards). I wouldn't expect a hardwood to break apart like it has near the tap.

TBH, it may be cheaper to get a new worktop when you factor in the cost of sanding and repairing the current one.
 
Iroko?

Mind you the worktop looks like it has been made out of planks of wood (possibly even floorboards). I wouldn't expect a hardwood to break apart like it has near the tap.

TBH, it may be cheaper to get a new worktop when you factor in the cost of sanding and repairing the current one.

It looks like a hardwood to me - the split around the taps is where the staves have been jointed as far as I can tell. It looks like the staves are long and wide - typically this would indicate it’s an expensive, high quality wood top.

I’d definitely look to repair it. Challenging to tell the wood just by sight with wear and and stains on it. Obviously best to remove and start the repair process. Hopefully you will have a powerful clamp that can pull and glue back in the stave split, assuming its warped and not bulged.

Good luck.
 
It looks like the staves are long and wide - typically this would indicate it’s an expensive, high quality wood top.

Fair call, thanks.

I have never seen staves that wide before.

I stand corrected.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top