• Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.

Recent content by dazzled1

  1. D

    Tiling to the floor

    Hi I'm tiling a wall and ending on a vinyl floor in our bathroom. The previous lot of tiling had a bit of skirting board at the bottom but I want to try and avoid it if possible. I wondered what products out there that give a good finish when joining floor to vinyl. I am imagining something...
  2. D

    Tiling 2/3 plastering 1/3

    Sounds like a good plan, thanks very much.
  3. D

    Tiling 2/3 plastering 1/3

    Hi, Quick question... on two walls of our bathroom we want to tile the bottom 2/3rds and paint the top 1/3. The whole walls are covered with cement backer board (hardibacker I think). My question is can I do the tiling on the bottom 2/3rds then get someone in to plaster the top 1/3 or will...
  4. D

    Hot water pressure very low

    Thanks very much mate, was exactly that. Figured out there was a kink in the flexible bit of pipe because I was having to go at a 90° angle in a tight space. Going to need to slightly re-route the pipe but at least I know what the problem is. Ta muchly.
  5. D

    Hot water pressure very low

    unfortunately the plumber is me :( I'll have a look along the pipes where I can and see if I can work out if it is a blockage.
  6. D

    Hot water pressure very low

    Hi, I have a strange problem (to me) where the hot water pressure in the bath is very low. The reason I think it is strange is because the basin is fine (which is actually higher up than the bath). We have a combi-boiler powering both. The hot water pressure seems to be so low that is...
  7. D

    Waste Pipe to Soil Stack - 200mm problem...

    Cheers doitall - I also asked this on another forum where someone said the same. Seems so obvious now i don't know why I didn't think of it.
  8. D

    Waste Pipe to Soil Stack - 200mm problem...

    Hi people, I have a bit of a issue with the best way to go about connecting a 32mm waste pipe (from a new basin) to a cast iron soilpipe. I have figured I can get a strap on boss (probably from Saint Gobain as they do good ones for CI) and fit it ok. My only problem is getting the 200mm...
Back
Top