Recent content by djwarr20

Thanks for the reply. I will get a straight edge and work out how much. If it does need levelling can you recommend the best compound to use? Many thanks

I am planning on laying my engineered wood flooring with Sikabond T52 to the concrete base. I am using this method as I have UFH Is it best to use a self levelling compound first to get the base completely flat or is there some tolerance when using the adhesive (my floor isn’t too far out but...

Thanks for this info. Should I purchase IP65 rated GU10's?

Sorry forgot to say its plastic soffit and its more for effect than to actually light up anything. Cheers

I’m looking to put some downlights in the soffit for my extension. However I am after a blue type of light - whats the best type of light and lamp for this? I have done a few searches on this forum but haven’t found an definitive answer. Cheers

Thanks for the replies. It has all been done and passed by building control but wasn't sure on the connection. Thanks!

I have had a new single story extension built. Drainage for a new downstairs toilet has been installed. The origianl manhole was relocated (as it would have been in the extension) and a new run for the downstairs toilet was made directly to the new manhole (this is only servicing the toilet...

Thanks Noseall I will use this method if I can't find any adaptors. Anyone else now where i can buy these from? Thanks

Hi Where can i buy the connecting peice to hook up the vent to 100mm pipe?? http://www.toolstation.com/shop/Structural/Roofline+Ventilation/9+x+3+Telescopic+Vent+Black/d210/sd2747/p38967 Thanks!

can anyone advise on how to get the PCB out of this type of dishwasher. thanks

ok thanks so basically use a fused spur with 3 or 5 amp fuse in it?

can i spur off a power socket to feed a set of downlighters? thanks