Hi All - Looking for some advice...
Just moved into a new house, and inthe garage there is a soil pipe going into the concrete floor.
There was a very light looking damp mark all around the soil pipe, but you would only notice if you looked hard. There also appeared to be some material of...
Just another thing I noticed, the flue out the boiler is about 2m across the garage before it exits through the wall (basically two 1m lengths of flue joined together). This does not look like there is a bracket anywhere holding the length - again is this ok?
Hi - This is the picture of my flue. The flue constantly drips, which as I say makes the wall at ground level soaking (the cold weather caused this to ice up and ice was creeping up the wall).
Can anyone tell me if this looks ok?
Thanks for that, so just to confirm, the flue should rise at an angle so the dripping water runs back into the boiler? Do you think I could change this myself? The hole in the wall will already be cut... is there enough room to move the flue up without leaving a big gap in the wall? Or should...
Hi - I've recently had a WB 37cdi installed. The flue is horizontal through the garage wall. I have noticed the plume is very think (this may be because of the cold weather, but compared to my neigbours, it is excessive). The main thing that concerns me is the wetness on the wall and floor...
Hi Guys
I have had a WB 37CDI installed, the fitter was offering me a daily thermostat, but I really want the 7 day type.
I have decided on either the Honeywell CM 927 or the Siemens REV23RF.
Can you advise which is the better one?
All the best...
(and if you are reading this on...
Hi All
Can anyone advise if this sounds correct....
I have just bought a house, and the owners could not provide a FENSA certificate for a PVC french door they installed. Instead they provided Indemnity Insurance.
When I moved in, I noticed the carpet near the door was soaking, and...