Recent content by earlyriser

I have uploaded an image in my album but I don't know how to send to to you Let me know if you can see it ?

As you can see I don't know how to use this site the track is 16mm by 8mm external with thickness 1 mm u shaped channel and ball on top

plus ball on top 1mm thickness

Photos

Hi I have a set of UPVC Patio doors from Wickes circa 2001 I am trying to locate track I t appears to clip over a plastic upstand with no screws or obvious fixings, About 18 mm wide with channel underneath and runner ball on top very simple just cant find one ? Help Earlyriser

Hi Batman the pipes below are solid copper, but I will try your tip will let yyou know Earlyriser

My kitchen mixer taps only produce a trickle in the hot water position. The cold water is fine. I have taken apart and there is a plastic cartridge inside which all appears to be in good condition.all washers etc fine.I am wondering if there could be a blockage in the outlet on the hot side or...

I have a Karcher 211 pressure washer. It has started to switch itself on and off continually in standby mode instead of staying off while not actually jet washing.The pressure valve to operate the electrics just keeps moving back and forward. Any ideas ? Also been on the karcher site but cant...

I am replastering internally a listed building and have to use lime mortar plaster. I have to use washed sand mix 3 to 1 with hydraulic lime. The builders merchant have sent me a large bag of sand with a 6 to 1 mix of a reddish sand which appears to be building sand and they say it is ok to...

I Have a Rockworth hammer/breaker,the sds driill bit has broken inside the chuck,I have removed a circlip,I have removed a circlip and washer but cannot remove the plastic shroud of the chuck, can anyone help. Alternatively has anyone got any information on Rockworth of Doncaster eg technical...

I have had a service engineer out to my boiler and he has given me a warning notice to say that because the PRV pipework is run from the boiler to outside in speedfit pipe and connectors it is at risk of melting in the event of a blowout and should be only installed in copper ? I believe that as...