ericmark's latest activity

  • ericmark
    ericmark reacted to Madrab's post in the thread Scalding water with Hive with Thanks Thanks.
    As per the 2010 revised regs - all new builds or new baths in existing should have TMV2 mixing valves fitted to baths, regardless of tap...
  • ericmark
    ericmark replied to the thread Scalding water with Hive.
    Not a plumber, but I thought these valves allow cooler hot water from the taps where mixer taps are not used, the tank water temperature...
    • 1769344061760.png
  • ericmark
    Nest Gen 3 can replace this it will need bridge wires L to both Coms and leave the old thermostat at full. The new thermostat should...
    • 1769342986543.png
    • 1769343393575.png
  • ericmark
    There's your diode, should not use a three port valve with a type AC RCD I assume, but never seen a warning about it! But think the two...
    • mid-position-valve.jpg
  • ericmark
    ericmark replied to the thread Unstoppable Mold.
    70% relative humidity at 10°C is not a problem. Need to quote both relative humidity and temperature for it to have any meaning.
  • ericmark
    The problem is my hand has been de-gloved in an industrial accident. This means I have a problem if either too hot or too cold, just...
    • 1769303402815.png
  • ericmark
    Seem to remember there was a sequence of events which could leave it activated even with heating off?
  • ericmark
    ericmark replied to the thread Unstoppable Mold.
    Yr Wyddgrug has been around for a long time, English name Mold, being in a valley it does get wet, and the Alyn does flood from time to...
    • 1769274790339.png
  • ericmark
    ericmark replied to the thread Thermostat cut-out with a twist.
    My cylinder had a 9-inch thermostat, think element was 11 inches, since using solar to heat DHW were using it all the time, and it kept...
  • ericmark
    Yes, very aware of problem with discharged batteries. One reason for going with Nest to start with, the 12 volt DC comes from the hub...
    • 1769268487232.png
    • 1769268623464.png
  • ericmark
    There are many TRV heads, some which are truly smart, working out how long it takes to heat a room, so it can start heating the room at...
  • ericmark
    Thank you, @SUNRAY very well put, the problem is we have intelligent TRV heads able to work out how long it takes to heat a room, and...
  • ericmark
    ericmark reacted to SUNRAY's post in the thread Is this article a Red Haddock ??? with Like Like.
    In a system there has to be some form of thermal control, in a conventional system of rads and balanced lockshields that'll be a space...
  • ericmark
    Yes, that does seem to be a major problem. But the other is the fitting of on/off zone valves, why would anyone in their right mind fit...
  • ericmark
    I did say my boiler does not modulate. So on/off only option for me. But I looked at mother's gas boiler, and it did not modulate that...
Back
Top