Exedon's latest activity
-
Exedon replied to the thread Access to tap fittings advice.Welcome to our world! There must be some sort of gap behind sink for flexis from tap to pass through. There are long box spanner sets... -
Exedon replied to the thread Pipe identification.If its newbuild that's aluminium tape behind pipes. It's so you can locate them! Plus pipes should be in a correct zone. Yes you ideally...
-
Exedon replied to the thread Why is my mains pipe going up the 1st floor?.As you have worked out original mains supply went to feed cistern (tank) and everything low pressure from there. Yes feed everything as...
-
Exedon replied to the thread Simple swap / replacement for old CH / HW timer? Pictures of old one..If you want to stay with same footprint and features that's as good as it gets. SMC were actually a pump manufacturer long gone .
-
If it's a 2 port valve then place a demand and test the wire going to the brown of the motorised valve using a suitable tester to earth...
-
Exedon replied to the thread Boiler Pressure Dropped.Unless either the boiler or heating system has a auto air valve somewhere then when air is removed pressure will drop.
-
Exedon replied to the thread Notable Obituaries..Gilson Lavis Just seen on Jools Holland's Facebook page that his long time drummer both with squeeze and the rhythm and blue orchestra...
-
Exedon replied to the thread Cracked shower tray.Should have been sorted as soon as cracks appeared. Who supplied tray? If your installer didn't fix tray as per manufacturers...
-
+1 - Not what you want to hear but - once they are cracked then really it's time to change, the trouble is the existing cause would...
-
Exedon replied to the thread Cracked shower tray.We subcontracted to a specialist insurance contractor for over 10 years. I've seen just about ever conceivable of attempted repair on...
-
Exedon reacted to Madrab's post in the thread How long does Drayton MA1 mid-position actuator last?? with
Thanks.
If there's one thing you can be sure of, it's a mid position valve whose motor will eventually burn out. Honestly, as suggested, get it... -
Exedon replied to the thread How long does Drayton MA1 mid-position actuator last??.Truly dreadful things I've seen them last considerably less than 7 years. If body needs changing we rip them out and fit 2 zone valves.
-
Exedon replied to the thread Boiler sizing query?.Should have been a full room by room heat loss calculation done, only accurate way to size boiler. Also with a heat only boiler I'd use...
-
Exedon replied to the thread Which shower pump ?.Have you considered going the pressurised cylinder route (assuming decent cold mains pressure/flow) no pump or storage cistern required.
-
Exedon replied to the thread Inlet on radiator now on the opposite side.If you have removed old rad link valves with a bit of 15mm pipe turn valves on then turn on heating.