Recent content by fanch

I tested another configuration "System - Mains Power Off" now it works. when I turn off the power and the output is now activated. I don't understand why the "Aera - Fault Present" configuration does not work ?

I'm going to test with a different output setup ("System" - "Mains Power Off" for example) and will give you feedback.

Thanks for the cable advice, but it's not a cable problem because the other outputs work correctly. The problematic output has been tested and does activate the relay.

Yes, but it's still powered by the battery. The relay, connected to the output and also powered by the battery, isn't activating either.

Could disabling Pir's zones from "Alter Part Arms" menu be a solution?

I tried it but result does not change. Updating the firmware (currently V3.0) will resolve the issue ?

Why not, i will try it

In this special case, am I to understand that the omited zone is considered as armed status and therefore validates the output ? Is there a workaround to use "Output Group - Zone" without activating it when omited ?

Hello, The goal is to be alerted when the alarm system malfunctions (tamper no, power outage, ... for example). All 8 outputs, including the one in question (output number #8), are connected to a relay that communicates with a GSM transmitter to notify by SMS. Yes, the input (number #8) has...

To clarify the process: The output is configured so that a fault activates it (Output Group - Area / Fault Present). To verify if the output is activated during a fault, the power to the control unit is cut off at the main electrical panel. The result is no activation of the output despite the...

Panel : Premier Elite 48W Live Software version : 3.0 When I cut the main power, the alarm is displayed on the keypad but the output does not activate Output setting : Output Group - Area / Fault Present Installation Manual documentation : 66 - Fault Present : This output type activates when...

Hello, I configured a Digital Output as an "Output Group - Zone" with the "Mimic Armed" option. However, when Part Arming, PIRs sensors (omited in this Part Arm) activates the output. How do I disable output in this case ? Regards, François.

Does anyone have any ideas?

Power off delay has been set to 0 but nothing changed. I am using Digi Outputs #8 and the trigger is cuting off main power on PCB.

Hello, I want to activate an output when the main power is cut off, but outputs "Aera - Fault Present" or "System - Mains Power Off" do not activate when the main power is Off.